EVR-GARD COATINGS CO -- LATEX SEMI-GLOSS PAINT, 4300  -- 8010-01-280-9052
<pre>=====================  Product Identification  =====================

Product ID:LATEX SEMI-GLOSS PAINT, 4300
MSDS Date:07/06/1992
FSC:8010
NIIN:01-280-9052
=== Responsible Party ===
Company Name:EVR-GARD COATINGS CO
Address:16400 GARFIELD AVE
City:PARAMOUNT
State:CA
ZIP:90723
Country:US
Info Phone Num:213-531-0131
Emergency Phone Num:213-531-0131
CAGE:5G582
=== Contractor Identification ===
Company Name:EVR-GARD COATINGS CO
Address:16400 GARFIELD AVE
Box:City:PARAMOUNT
State:CA
ZIP:90723
Country:US
Phone:310-531-0131
CAGE:5G582

=============  Composition/Information on Ingredients  =============

Ingred Name:ETHYLENE GLYCOL (SARA 313) (CERCLA). VP:0.1 @ 68F.
CAS:107-21-1
RTECS #:KW2975000
Fraction by Wt: 1.38%
OSHA PEL:50 PPM (MFR)
ACGIH TLV:50 PPM, VAPOR, C
EPA Rpt Qty:1 LB
DOT Rpt Qty:1 LB

Ingred Name:VOLATILE ORGANIC COMPOUNDS: COATING - 0.75 LBS/GAL (90
    G/L).
RTECS #:9999999VO

=====================  Hazards Identification  =====================

LD50 LC50 Mixture:NONE SPECIFIED BY MANUFACTURER.
Routes of Entry: Inhalation:YES  Skin:YES  Ingestion:YES
Reports of Carcinogenicity:NTP:NO    IARC:NO	OSHA:NO
Health Hazards Acute and Chronic:INHALATION:MAY CAUSE HEADACHE AND
    NAUSEA, DIZZINESS. SKIN AND EYE CONTACT AND SKIN
    ABSORPTION:PRIMARILY AN IRRITANT. REDNESS OR RASH ON SKIN.
    INGESTION:NAUSEA, DIZZINESS, HEADACHES.
Explanation of Carcinogenicity:NOT RELEVANT
Effects of Overexposure:SEE HEALTH HAZARDS.
Medical Cond Aggravated by Exposure:PROLONGED CONTACT WITH MATERIAL MAY
    CAUSE DERMATITIS.

=======================  First Aid Measures  =======================

First Aid:INHAL:REMOVE PATIENT TO FRESH AIR. EYES:FLUSH W/PLENTY OF
    CLEAN WATER FOR AT LEAST 15 MINUTES. SKIN:REMOVE SATURATED,
    CONTAMINATED CLOTHING & WASH AFFECTED AREAS OF SKIN W/PLENTY OF
    SOAPY WATER THOROU GHLY. INGEST:INDUCE VOMITING W/1 OZ OF SYRUP OF
    IPECAC FOLLOWED IN 5 MINUTES W/GLASS OF WATER. CALL MD.

=====================  Fire Fighting Measures  =====================

Flash Point:241F,116C
Lower Limits:3.2%
Upper Limits:15.3%
Extinguishing Media:FOAM, ALCOHOL FOAM, CO*2, DRY CHEMICAL, WATER FOG.
Fire Fighting Procedures:USE NIOSH APPROVED SCBA & FULL PROTECTIVE
    EQUIPMENT . THIS IS A WATER-BASED PRODUCT. WILL NOT SUPPORT
    COMBUSTION.
Unusual Fire/Explosion Hazard:NONE.

==================  Accidental Release Measures  ==================

Spill Release Procedures:ABSORB SPILL W/ANY ABSORBENT MATERIAL -
    SAWDUST, SAND, CLAY, ETC & FLUSH SPILL AREA W/LOTS OF WATER.
Neutralizing Agent:NONE SPECIFIED BY MANUFACTURER.

======================	Handling and Storage  ======================

Handling and Storage Precautions:THIS PRODUCT IS STABLE UNDER NORMAL
    USE & STORAGE CONDITIONS. KEEP OUT OF REACH OF CHILDREN. KEEP FROM
    FREEZING.
Other Precautions:DO NOT TAKE INTERNALLY.

=============  Exposure Controls/Personal Protection  =============

Respiratory Protection:THE USE OF NIOSH APPROVED MASKS DURING
    APPLICATION TO AVOID EXCESSIVE INHALATION OF VAPORS IS HIGHLY
    RECOMMENDED. OPEN WINDOWS & DOORS OR USE OTHER MEANS TO INSURE
    FRESH AIR ENTRY DURING APPLICATION &  DRYING.
Ventilation:PROVIDE ADEQUATE VENTILATION AT ALL TIMES DURING HANDLING &
    APPLICATION OF THIS PRODUCT. INSURE ADEQUATE SUPPLY (SUPDAT)
Protective Gloves:BUNA N GLOVES.
Eye Protection:ANSI APPROVED CHEM WORKERS GOGGS .
Other Protective Equipment:EYE WASH FOUNTAIN & DELUGE SHOWER WHICH MEET
    ANSI DESIGN CRITERIA .
Work Hygienic Practices:OBSERVE STANDARD HYGIENE PRACTICES WHEN
    HANDLING THIS PRODUCT.
Supplemental Safety and Health
VENT:OF FRESH AIR AT ALL TIMES.

==================  Physical/Chemical Properties  ==================

Boiling Pt:B.P. Text:387F,197C
Vapor Pres:SEE ING 1
Vapor Density:HVR/AIR
Spec Gravity:1.2 (H*2O=1)
Evaporation Rate &amp; Reference:SLOWER THAN ETHER
Solubility in Water:DILUTABLE
Appearance and Odor:WHITE PAINT & COLORS; SLIGHT AMMONIA SMELL.

=================  Stability and Reactivity Data  =================

Stability Indicator/Materials to Avoid:YES
STRONG ACIDS & ALKALIS & MATERIALS THAT REACT W/WATER.
Stability Condition to Avoid:DO NOT STORE IN HIGH TEMPERATURE AREAS.
Hazardous Decomposition Products:NONE.

====================  Disposal Considerations  ====================

Waste Disposal Methods:PLACE ALL HAZARDOUS WASTES, INCLUDING ABSORBENTS
    USED FOR SPILLS, IN 55-GAL DRUMS & DISPOSE IN APPROVED DUMPSITE
    I/A/W PRECRIBED FEDERAL, STATE & LOCAL REGULATIONS.

 Disclaimer (provided with this information by the compiling agencies):
 This information is formulated for use by elements of the Department
 of Defense.  The United States of America in no manner whatsoever,
 expressly or implied, warrants this information to be accurate and
 disclaims all liability for its use.  Any person utilizing this
 document should seek competent professional advice to verify and
 assume responsibility for the suitability of this information to their
 particular situation.